Ignition Coils: Installation

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install ignition coil to bracket with screws supplied with replacement ignition coil. To complete installation, reverse removal procedure. Tighten ignition coil mounting studs to specification. See TORQUE SPECIFICATIONS .

Fig 1: Removing Ignition Coil Wire (4.3L)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing Ignition Coil (4.3L)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing Ignition Coil & Ignition Control Module From Mounting Bracket (4.3L)

Courtesy of GENERAL MOTORS CORP.