LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls - Removal, Overhaul & Installation - Except Diesel) >> Ignition Systems >> Distributor >> Installation (Engine Has Not Been Rotated With Distributor Removed)

Installation (Engine Has Not Been Rotated With Distributor Removed)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. To ensure correct timing of distributor, install with rotor positioned as it was when distributor was removed. Align distributor rotor with last mark made on distributor housing. Align bolt hole in distributor hold-down with threaded hole in intake manifold.
  2. Carefully lower distributor into engine. Distributor rotor should turn clockwise and line up with first reference mark made on distributor housing once fully seated into engine. Bolt hole in distributor hold-down should still be aligned with threaded hole in intake manifold.
  3. If distributor rotor is not properly aligned, remove distributor and repeat procedure until mark aligns properly. Install distributor hold-down bolt and tighten to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals