LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls - Removal, Overhaul & Installation - Except Diesel) >> Ignition Systems >> Camshaft Position Sensor >> Removal & Installation (4.8L, 5.3L & 6.0L)

Removal & Installation (4.8L, 5.3L & 6.0L)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean area around Camshaft Position (CMP) sensor before removal to prevent debris from entering engine. CMP sensor is located at the top center rear of engine. See Fig 1.
  2. Loosen retaining bolt on intake manifold sight shield at top of engine. See Figure. Remove intake manifold sight shield from top of engine. Disconnect CMP sensor harness connector.
  3. Remove CMP sensor retaining bolt. See Fig 2. Remove CMP sensor. To install, reverse removal procedure. Tighten CMP sensor retaining bolt to specification. See TORQUE SPECIFICATIONS .
Fig 1: Locating Camshaft Position Sensor & Engine Oil Pressure Sensor (4.8L, 5.3L & 6.0L)
G00113342Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Camshaft Position Sensor (4.8L, 5.3L & 6.0L)
G00156234Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals