LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1120 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Balancer
    GM1394039Courtesy of GENERAL MOTORS CORP.
  1. Remove the accessory drive belt. Refer to Drive Belt Replacement .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Use the J 41816-A  in order to remove the crankshaft balancer. Refer to Crankshaft Balancer Removal .
  4. Use a utility stand to support the right side of the frame and powertrain.
  5. Remove the right side frame bolts. Refer to Frame Replacement - Front (W/AWD) or Frame Replacement - Front (W/FWD) in Frame and Underbody.
  6. Raise the vehicle or lower the frame and powertrain in order to gain access to the crankshaft balancer.
scientia non olet · About LEMON Manuals