Crankshaft Balancer Removal

Tools Required

• EN 46106  Flywheel Holding Tool
• J 38416-2  Crankshaft Button
• J 41816 Crankshaft Balancer Remover

Fig 1: View Of Tool EN 46106
Courtesy of GENERAL MOTORS CORP.
1. Install the EN 46106  through the starter mounting hole.
Fig 2: Identifying Crankshaft Balancer Bolt
Courtesy of GENERAL MOTORS CORP.
2. Remove the crankshaft balancer bolt.
Fig 3: View Of J 38416-2 In The Nose Of The Crankshaft
Courtesy of GENERAL MOTORS CORP.
3. Install the J 38416-2  in the nose of the crankshaft.
4. Install the J 41816 in order to remove the crankshaft balancer.
5. Tighten the center bolt of the J 41816 in order to pull the crankshaft balancer off of the crankshaft.
6. Remove the J 41816 from the crankshaft balancer.