High Beam Indicator Inoperative
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
High Beam Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics Connector End View Reference: Master Electrical Component List in Wiring Systems. |
|||
| 1 | Did you perform the Lighting System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Lighting Systems |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 4 |
| 3 | Test for a poor connection, short to ground, or an open in the high beam signal circuit of the BCM. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Inspect for a poor connection at the harness connector of the instrument cluster. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 | Replace the instrument cluster. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages and Console. Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |