LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Lighting Systems) >> Diagnostic Information and Procedures >> Headlamps Inoperative - Low and High Beams

Headlamps Inoperative - Low and High Beams

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Headlamps Inoperative - Low and High Beams

Step Action Yes No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics 
Connector End View Reference: Master Electrical Component List in Wiring Systems.
DEFINITION: All the headlamps are inoperative.
1 Did you perform the Lighting System Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2
  1. Turn the headlamp switch to the HEAD position.
  2. Place the headlamp dimmer switch in the LOW position.
  3. Place the headlamp dimmer switch in the HIGH position.
Do the all headlamps operate properly?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Inspect the headlamp switch signal circuit for an open or a short to battery positive voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 6  Go to Step 4 
4 Inspect the headlamp switch ground circuit for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 6  Go to Step 5 
5 Replace the headlamp switch. Refer to Headlamp Switch Replacement .
Did you complete the repair?
Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3