LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Lighting Systems) >> Diagnostic Information and Procedures >> Backup Lamps Inoperative

Backup Lamps Inoperative

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Backup Lamps Inoperative

Step Action Yes No
Schematic Reference: Exterior Lights Schematics 
Connector End View Reference: Master Electrical Component List in Wiring Systems.
1 Did you perform the Lighting System Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2
  1. Turn ON the ignition.
  2. Place the gear selector lever to the REVERSE position.
Do both backup lamps illuminate?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Remove the backup lamps relay.
  2. Install a fused jumper between the ignition 1 positive voltage supply circuit and the backup lamps relay switched voltage supply circuit.
Do the backup lamps illuminate?		 Go to Step 5  Go to Step 4 
4 Test for a short to ground or an open in the backup lamps relay switched voltage supply circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 8 
5
  1. Using a test lamp, connected to battery positive voltage, probe the backup lamps relay coil control circuit.
  2. Turn the ignition to the ON position.
  3. Apply the brakes.
  4. Place the gear selector to the Reverse position.
Does the test lamp illuminate?		 Go to Step 6  Go to Step 8 
6 Replace the backup lamps relay. Refer to Relay Replacement (Attached to Wire Harness) or Relay Replacement (Within an Electrical Center) in Wiring Systems.
Did you complete the repair?		 Go to Step 9  -
7 Replace the console electrical center. Refer to Console Electrical Center or Junction Block Replacement in Wiring Systems.
Did you complete the repair?		 Go to Step 9  -
8
IMPORTANT: Perform the BCM Reprogram procedure. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control Systems.
Replace the BCM. Refer to Body Control Module Replacement in Body Control Systems.Did you complete the replacement?		 Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals