Electronic Column Lock Module - Disassemble - Off Vehicle (Standard Column)
- Disable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM
.
- Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle
.
- Remove the turn signal cancel cam, bearing thrust washer. Refer to Turn Signal Cancel Cam & Bearing Thrust Washer - Disassemble - Off Vehicle
.
- Remove the ignition and key alarm switch assembly only. Refer to Ignition & Key Alarm Switch Assembly - Disassemble - Off Vehicle
.
- Remove the park lock cable assembly (1) from the electronic lock module assembly.
- Place the lock cylinder in the OFF-LOCK position.
- Place the shift lever clevis into the PARK position.
- Insert a small screwdriver into the slot on the electronic lock module assembly. Push against the locking tab on the end of the park lock cable assembly (1).
- Disconnect the park lock cable assembly (1) from the electronic lock module assembly.
Courtesy of GENERAL MOTORS CORP.
- Remove the 3 pan head tapping screws (2) from the electronic lock module assembly (1).
- Remove the electronic lock module assembly (1) from the steering column housing assembly.
Courtesy of GENERAL MOTORS CORP.