LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 845 (Parking Brake System) >> Repair Instructions >> Park Brake Lever Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disengage Retainer Clips On Park Brake Lever Boot
    GM63996Courtesy of GENERAL MOTORS CORP.
  1. Remove the accessory trim plate. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  2. Remove the passenger seat. Refer to Seat Replacement (Power) or Seat Replacement (Manual) in Seats.
  3. Lift and disengage retainer clips on park brake lever boot.
    4. Fig 2: Parking Brake Electrical Connector
    GM63992Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the parking brake electrical connector.
  5. Disable the parking brake automatic adjuster. Refer to Disabling the Park Brake Cable Automatic Adjuster .
    6. Fig 3: Parking Brake Lever Assembly Mounting Bolts
    GM63998Courtesy of GENERAL MOTORS CORP.
  6. Remove the parking brake lever assembly mounting bolts.
  7. Reposition the park brake lever.
    8. Fig 4: Front Parking Brake Cable To Drive Sector & Park Brake Lever Assembly
    GM404107Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the front parking brake cable from the drive sector and park brake lever assembly.
scientia non olet · About LEMON Manuals