LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 845 (Parking Brake System) >> Repair Instructions >> Disabling the Park Brake Cable Automatic Adjuster

Disabling the Park Brake Cable Automatic Adjuster

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Park Brake Cable To Rear Suspension Mounting Bracket
    GM64001Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Disconnect the park brake cable from the left and right park brake actuators.
  4. Lower the vehicle.
  5. Reposition carpet away from park brake lever.
    6. Fig 2: Park Brake Cable At Rivet To Park Brake Lever
    GM204307Courtesy of GENERAL MOTORS CORP.
  6. With the aid of an assistant, pull the disconnected park brake cable downward until it is fully extended and insert a rivet, drill bit or cotter key through the holes in the park brake lever mechanism as they line up. Do not overextend the cable.
scientia non olet · About LEMON Manuals