Turn Signal Switch Housing - Assemble - Off Vehicle (Aurora)

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Install the turn signal switch housing (2) to the steering column tilt head assembly.
CAUTION: Refer to FASTENER NOTICE .
Install the 2 pan head tapping screws (1).
Tighten

Tighten the screws to 7 N.m (62 lb in).

Fig 1: Installing Turn Signal Switch Housing
Courtesy of GENERAL MOTORS CORP.
Slide the windshield wiper and washer switch assembly into the turn signal switch housing until the tabs lock in place.
CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION .
If necessary, connect the windshield wiper and washer switch assembly connector.
Install the upper tilt head components. Refer to Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle .
Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM .

Fig 2: Installing Windshield Wiper & Washer Switch Assembly
Courtesy of GENERAL MOTORS CORP.