LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> System Testing >> Park Brake System Testing

Park Brake System Testing

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Were you sent here from a Hydraulic Brake Symptom List? If so, go to step  4 . If not, go to next step.
  2. Were you sent here from a Park Brake Symptom List? If so, go to step  4 . If not, go to next step.
  3. Is the symptom related to the ability of the park brake system to hold and/or release? If so, go to DIAGNOSTIC STARTING POINT - PARK BRAKE  under TROUBLE SHOOTING. If not, go to DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKE  under TROUBLE SHOOTING.
  4. Raise and support the vehicle with the rear axle supported by jack stands. With the park brake RELEASED, attempt to rotate the rear wheels to check the rear brakes for a significant amount of drag. Do the rear brakes have a significant amount of drag? If so, go to step  11 . If not, go to next step.
  5. Apply the park brake. Attempt to rotate the rear wheels to check the rear brakes for a significant amount of drag. Do the rear brakes have a significant amount of drag? If so, go to next step. If not, go to step  7 .
  6. Release the park brake. Rotate the rear wheels to check the rear brakes for a significant reduction in the amount of drag. Did the rear brakes exhibit a significant reduction in the amount of drag? If so, go to step  21 . If not, go to step  11 .
  7. Visually check the park brake cable connections and the cables that are accessible on the UNDERSIDE of the vehicle for disconnections and/or damage. Were any or the park brake cables disconnected and/or damaged? If so, go to next step. If not, go to  9 .
  8. Reconnect or replace the park brake cables as necessary. See FRONT PARK BRAKE CABLE  , REAR LEFT PARK BRAKE CABLE  & REAR RIGHT PARK BRAKE CABLE  under REMOVAL & INSTALLATION. After repairs are complete, go to next step.
  9. Check the adjustment of the park brake. See DRUM PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Was the park brake adjusted properly? If so, go to step  11 . If not, go to next step.
  10. Adjust the park brake. See DRUM PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Were you able to attain adjustment of the park brake? If so, go to step  16 . If not, go to next step.
    11. NOTE: Do not depress the brake pedal with the brake rotors and/or the brake drums removed, or with the brake calipers repositioned away from the brake rotors, or damage to the brake system may result.
  11. Remove the brake drums. Inspect the park brake hardware for loose, damaged, broken or missing components. Check the drum brake adjusters for a seized condition. Does the park brake hardware and/or the park brake adjusters require replacement? If so, go to next step. If not, go to step  13 .
  12. Replace park brake hardware components as necessary. See PARK BRAKE HARDWARE  under REMOVAL & INSTALLATION. Replace the drum brake adjusters as necessary. After repairs are complete, go to next step.
  13. Have an assistant apply and release the park brake, while you observe the park brake cables for free movement. Did the park brake cables move freely? If so, go to next step. If not, go to step  17 .
  14. Check the adjustment of the park brake. See DRUM PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Was the park brake adjusted properly? If so, go to step  16 . If not, go to next step.
  15. Adjust the park brake. See DRUM PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Were you able to attain adjustment of the park brake? If so, go to next step. If not, go to step  26 .
  16. Apply the park brake. Attempt to rotate the rear wheels to check the rear brakes for a significant amount of drag. Release the park brake. Rotate the rear wheels to check the rear brakes for a significant reduction of drag. Did the park brake apply and release properly? If so, go to step  26 .
  17. Disconnect the park brake cable connections that are accessible on the UNDERSIDE of the vehicle one at a time and check each cable for free movement. Do any of the park brake cables accessible on the underside of the vehicle require replacement? If so, go to next step. If not, go to step  19 .
  18. Replace any of the park brake cables that do not have free movement (not releasing properly). See FRONT PARK BRAKE CABLE  , REAR LEFT PARK BRAKE CABLE  & REAR RIGHT PARK BRAKE CABLE  under REMOVAL & INSTALLATION. After repairs are complete, go to next step.
  19. Disconnect the front park brake cable connection accessible INSIDE the vehicle at the park brake pedal assembly and check for free movement. Replace the front park brake cable if it does not have free movement. See FRONT PARK BRAKE CABLE  under REMOVAL & INSTALLATION. Did you find and correct a condition? If so, go to step  24 . If not, go to next step.
  20. Replace the park brake pedal assembly (not releasing properly). See PARK BRAKE PEDAL  under REMOVAL & INSTALLATION. After repairs are complete, go to step  25 .
  21. Check the adjustment of the park brake. See DRUM BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Is the park brake adjusted properly? If so, go to step  28 . If not, go to next step.
  22. Adjust the park brake. See DRUM BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Were you able to attain adjustment of the park brake system? If so, go to step  27 . If not, go to next step.
  23. Remove the brake drums, if they have not yet been removed. Check the drum brake adjusters for a seized condition. Replace the drum brake adjusters as necessary. Did you find and correct a condition? If so, go to next step. If not, go to step  26 .
  24. Adjust the park brake. See DRUM BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Were you able to attain adjustment of the park brake system? If so, go to step  27 . If not, go to step  26 .
  25. Replace the component that is used to adjust the park brake system. See PARK BRAKE PEDAL  under REMOVAL & INSTALLATION. Adjust the park brake. See DRUM BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Did you complete the replacement and adjustment? If so, go to step  27 .
  26. Replace the component that is used to adjust the park brake system. SeePARK BRAKE PEDAL  under REMOVAL & INSTALLATION. Adjust the park brake. See PARKING BRAKE ADJUSTMENT - DISC BRAKES  under ADJUSTMENTS & INSPECTIONS. Did you complete the replacement and adjustment? If so, go to next step.
  27. Apply the park brake. Attempt to rotate the rear wheels to check the rear brakes for a significant amount of drag. Release the park brake. Rotate the rear wheels to check the rear brakes for a significant reduction of drag. Did the park brake apply and release properly? If so, go to next step.
  28. Install or connect any components that were removed or disconnected during diagnosis. Did you complete the operation? If so, system is okay. If system is not okay, go to step  3 .
scientia non olet · About LEMON Manuals