LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Adjustments & Inspections >> Drum Brake Adjustment

Drum Brake Adjustment

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Remove the rear wheels and tires. Relieve cable tension from the park brake system at the equalizer. There should be no tension on the park brake cables, so that the brake shoes are positioned only by the adjuster strut.
  2. Remove the rear drums. Set the Drum-to-Brake Shoe Clearance Gage (J-21177-A) so that the Drum-to-Brake Shoe Clearance Gage contacts the inside diameter of the drum at the widest point. Position the Drum-to-Brake Shoe Clearance Gage over the shoes at the widest point. Turn the adjuster nut until the shoes just contact the Drum-to-Brake Shoe Clearance Gage.
  3. Repeat for the other rear brake assembly. Install the rear drums. Install the rear wheels and tires. Adjust the park brake cable system. See DRUM PARK BRAKE ADJUSTMENT  . Lower the vehicle.
scientia non olet · About LEMON Manuals