LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Wheel Cylinder >> Installation

Wheel Cylinder: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply LOCTITE(R) GM P/N 12345382 (or equivalent) to the wheel cylinder shoulder face which contacts the backing plate. Use the Brake Shoe Spanner and Spring Remover in order to spread the brake shoes apart. Install the wheel cylinder. Install the wheel cylinder bolts. Tighten the bolts to specifications. See TORQUE SPECIFICATIONS  .
  2. Remove the cap from the brake pipe and install the brake pipe to the wheel cylinder. Tighten the nut to specifications. See TORQUE SPECIFICATIONS  .
  3. Adjust the brake shoes. See DRUM BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Install the brake drum. See BRAKE DRUM  . Bleed the hydraulic brake system. See BLEEDING BRAKE SYSTEM  . Install the tire and wheel. Lower the vehicle.
scientia non olet · About LEMON Manuals