LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 299 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Driver-side)

Removal & Installation (Driver-side)

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. On models with tilt steering, lower steering wheel. Turn steering wheel so slot on rear of steering wheel is accessible. Insert Air Bag Module Remover (J43298) into holes on rear of steering wheel to release both spring loaded air bag retainers. See Figure. Turn steering wheel 180 degrees and release remaining spring retainers. Pull driver-side air bag module away from steering wheel. Make note of wiring positions when removing air bag module. See Figure.
  3. Remove Connector Assurance Position (CPA) clip and disconnect driver-side air bag module connector. Disconnect horn ground lead from steering wheel. Rotate horn contact lead counterclockwise 1/4 turn to release from steering wheel. Remove driver-side air bag module.
  4. To install, reverse removal procedure. Ensure wires are routed correctly and are not pinched during installation. Ensure driver-side air bag module is seated completely. Activate air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals