LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 299 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Disabling System >> Zone 3

Zone 3

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key.
  2. Remove fuse block cover. Remove SDM fuse (15-amp) from fuse block, located on right side of instrument panel.
  3. Remove driver-side lower B-pillar trim panel. Remove Side Impact Sensor (SIS). See SIDE IMPACT SENSOR (SIS)  under REMOVAL & INSTALLATION. Remove Connector Position Assurance (CPA) clip from SIS harness connector. Disconnect SIS harness connector.


  1. Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key.
  2. Remove fuse block cover. Remove SDM fuse (15-amp) from fuse block, located on right side of instrument panel.
  3. Remove driver-side knee bolster. Remove Connector Position Assurance (CPA) clip from driver-side air bag module connector. See Fig 1. Disconnect driver-side air bag module connector.
Fig 1: Identifying Driver-side Air Bag Module Connector
G99E26207Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals