LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Tracker 2D Utility, 4WD, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical - 2.0L DOHC 4-Cylinder >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. To install reverse removal procedure. Before installing cylinder head bolts, apply light coating of engine oil to entire length of bolts below bolt heads. Tighten cylinder head bolts, and camshaft bearing cap bolts in sequence and to specification. See Fig 2 and Fig 3 . See TORQUE SPECIFICATIONS . Align camshaft position sensor and cylinder head marks. Install camshaft position sensor to rear of camshaft.
  2. To complete installation, reverse removal procedure. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS . On 4WD models, adjust front wheel toe-in. See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.
    Fig 1: Camshaft Bearing Cap Bolt Loosening Sequence
    G99A04526Courtesy of GENERAL MOTORS CORP.
    Fig 2: Cylinder Head Bolt Tightening Sequence
    G99C04527Courtesy of GENERAL MOTORS CORP.
    Fig 3: Camshaft Bearing Cap Bolt Tightening Sequence
    G99E04528Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals