Test P: Fasten Safety Belt Chime Always On
- If audible warnings system operation check has been performed, go to next step. If audible warnings system operation check has not been performed, perform audible warnings system operation check. See AUDIBLE WARNINGS SYSTEM OPERATION CHECK under TROUBLE SHOOTING.
- Turn ignition switch to RUN position. Disconnect driver's side seat belt switch 2-pin harness connector. If chime still sounds, go to next step. If chime stops sounding, go to step 4 .
- Turn ignition switch to LOCK position. Disconnect instrument cluster 16-pin harness connector. Disconnect chime audio alarm module 7-pin harness connector. Chime audio alarm module is located under left side of instrument panel, left of steering column. Disconnect Sensing and Diagnostic Module (SDM) 12-pin harness connector. SDM is located under center console. Measure resistance in Gray/Red wire between instrument cluster harness connector terminal No. 12 and chime audio alarm module harness connector terminal No. 1, SDM harness connector terminal No. 5 and seat belt switch terminal No. 2. See Figure -Figure . If resistance is less than 2 ohms on any circuit, go to step 5 . If resistance is 2 ohms or more on all circuits, go to step 6 .
- Replace seat belt buckle. After repair, perform AUDIBLE WARNINGS SYSTEM OPERATION CHECK under TROUBLE SHOOTING.
- Repair short to ground in Gray/Red wire between appropriate components. After repair, perform AUDIBLE WARNINGS SYSTEM OPERATION CHECK under TROUBLE SHOOTING.
- Replace chime audio alarm module. After repair, perform AUDIBLE WARNINGS SYSTEM OPERATION CHECK under TROUBLE SHOOTING.