LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Parking Brake System) >> Repair Instructions >> Park Brake Lever Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
  2. Release the tension from the park brake cable system. Refer to Disabling the Park Brake Cable Automatic Adjuster .
  3. Disconnect the electrical connector (1) from the park brake warning lamp switch.
    Fig 1: View Of Park Brake Lever Assembly
    GM741890Courtesy of GENERAL MOTORS CORP.
  4. Remove the front park brake cable end (3) from the lever reel assembly.
  5. Using the J 37043  , release the cable conduit end fitting (4) from the lever assembly (2).
    6. Fig 2: View Of Transmission Shift Control Assembly
    GM104495Courtesy of GENERAL MOTORS CORP.
  6. Remove the transmission shift control assembly mounting nuts.
    7. Fig 3: View Of Park Brake Lever Assembly
    GM741890Courtesy of GENERAL MOTORS CORP.
  7. Remove the park brake lever assembly rear mounting nut.
  8. Raise the shift control assembly just enough to allow the park brake lever assembly (6) to be removed.
  9. Remove the console attachment bracket.
  10. Remove the lever assembly (6).
scientia non olet · About LEMON Manuals