Disabling the Park Brake Cable Automatic Adjuster
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
- Ensure that the park brake lever assembly is fully released.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Have an assistant pull and hold the front park brake cable (3) toward the rear of the vehicle to cause the ratcheting cam of the park brake lever assembly to rotate backwards, against the clock spring.
- Have the assistant pull the front cable until the notch on the ratcheting cam (1) is visible through the opening in the cam cover plate (4).
- Push the pawl spring (5) downward toward the notch on the ratcheting cam (1).
- Have the assistant slowly release the cable to allow the notch on the cam (1) to catch the leg of the spring (5).