LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Parking Brake System) >> Repair Instructions >> Park Brake Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake lever assembly (6) into position.
    Fig 1: View Of Park Brake Lever Assembly
    GM741890Courtesy of GENERAL MOTORS CORP.
  2. Install the console attachment bracket.
  3. Install the transmission shift control assembly into position.
    Fig 2: View Of Transmission Shift Control Assembly
    GM104495Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the transmission shift control assembly mounting nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  5. Install the park brake lever assembly rear mounting nut.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

    Fig 3: View Of Park Brake Lever Assembly
    GM741890Courtesy of GENERAL MOTORS CORP.
  6. Install the front park brake cable to the lever assembly (2). Ensure that the conduit end fitting (4) is properly secured to the lever assembly.
  7. Install the cable end (3) to the lever reel assembly.
  8. Connect the electrical connector (1) to the park brake warning lamp switch.
  9. Restore the tension to the park brake cable system. Refer to Enabling the Park Brake Cable Automatic Adjuster .
  10. Install the floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals