Enabling the Park Brake Cable Automatic Adjuster
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Have an assistant pull and hold the front park brake cable (3) toward the rear of the vehicle to cause the ratcheting cam of the park brake lever assembly to rotate backwards, against the clock spring.
- Have the assistant pull the front cable (3) until the notch on the ratcheting cam (1) is released from the pawl spring (5).
- Have the assistant slowly release the cable to allow the cam (1) to coil properly.
- Fully apply and release the park brake lever 4-6 times to restore tension to the park brake cable system.
- Lower the vehicle.
- Install the floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.