LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (HVAC Systems - Manual) >> Diagnostic Information and Procedures >> Blower Motor Always On

Blower Motor Always On

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
Blower Motor Always On

Step Action Yes No
Schematic Reference: HVAC Schematics 
Connector End View Reference: HVAC Connector End Views 
DEFINITION: The blower motor is ON while the blower motor switch is in the OFF position.
1 Did you perform the HVAC Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - HVAC Systems - Manual 
2
  1. Turn ON the ignition, with the engine OFF.
  2. Place the blower motor switch in the OFF position.
Is the blower motor OFF?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Turn OFF the ignition.
  2. Disconnect the blower motor resistor assembly.
  3. Turn ON the ignition, with the engine OFF.
Is the blower motor OFF?
Go to Step 4  Go to Step 5 
4 Test the Low, Med 1 and Med 2 blower motor control circuits for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 8  Go to Step 6 
5 Test the High blower motor control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 8  Go to Step 6 
6 Inspect for poor connections at the harness connector of the HVAC control assembly. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 8  Go to Step 7 
7 Replace the HVAC control assembly. Refer to HVAC Control Assembly Replacement (Chevrolet)  or HVAC Control Assembly Replacement (Pontiac) .
Did you complete the replacement?
Go to Step 8  -
8 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2