LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Power Steering System) >> Repair Instructions >> Tie Rod End Replacement - Outer >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tie rod end (3) to the inner tie rod shaft (1).
    2. Fig 1: Identifying Outer Tie Rod End
    G01579884Courtesy of GENERAL MOTORS CORP.
  2. Install the outer tie rod ball stud (4) to the steering knuckle (6).
    NOTE: Refer to FASTENER NOTICE .
  3. Install the new prevailing torque nut (5) to the outer tie rod ball stud (4). Tighten the new prevailing torque nut to 45 N.m (33 lb ft).
  4. Install the front tire and wheel. Refer to TIRE & WHEEL REMOVAL & INSTALLATION .
  5. Adjust the front toe. Refer to FRONT TOE ADJUSTMENT .
  6. Tighten the jam nut (2). Tighten the jam nut to 75 N.m (55 lb ft).
scientia non olet · About LEMON Manuals