LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Side Impact Sensor (Sis) (SUNFIRE) >> Removal & Installation (Sedan)

Removal & Installation (Sedan)

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . For driver SIS, see ZONE 2 (SEDAN)  under DISABLING & ACTIVATING AIR BAG SYSTEM.. For passenger SIS, see ZONE 6 (SEDAN)  under DISABLING & ACTIVATING AIR BAG SYSTEM..
  2. Remove applicable lower B-pillar trim panel. Loosen bolts securing SIS to B-pillar. Remove SIS. Remove Connector Position Assurance (CPA) clip from SIS electrical connector. Disconnect SIS electrical connector.
  3. To install, reverse removal procedure. Tighten SIS bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. For driver SIS, see ZONE 2 (SEDAN)  under DISABLING & ACTIVATING AIR BAG SYSTEM.. For passenger SIS, see ZONE 6 (SEDAN)  under DISABLING & ACTIVATING AIR BAG SYSTEM..
scientia non olet · About LEMON Manuals