LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Analog Instrument Panels >> System Tests >> Test O: Fasten Seat Belt Indicator/Chime Always On >> Testing

Test O: Fasten Seat Belt Indicator/Chime Always On: Testing

  1. If diagnostic system check has been performed, go to next step. If diagnostic system check has not been performed, perform SEAT BELTS DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  2. Turn ignition switch to OFF position. Buckle driver's seat belt. Disconnect Body Control Module (BCM) 32-pin harness connector. BCM is located behind right side of instrument panel, near blower motor. See Figure. Turn ignition switch to RUN position. If fasten seat belt indicator stays on continuously, go to next step. If fasten seat belt indicator does not stay on continuously, go to step  4.
  3. Replace Instrument Panel Cluster (IPC). Program IPC. See INSTRUMENT PANEL CLUSTER  under PROGRAMMING. After replacement, go to step  7.
  4. Inspect Black/White wire for a short to ground between ground and BCM harness connector C3 terminal C13. If a short to ground is not found, go to next step. If a short to ground is found, repair as necessary then go to step  7.
  5. Inspect Black wire for an open or high resistance between ground and driver's seat belt switch harness connector terminal "B". If an open or high resistance is not found, replace driver's seat belt switch. If fasten seat belt indicator or chime concern still exists, go to next step. If an open or high resistance is found, repair as necessary then go to step  7.
  6. Replace BCM. Program BCM. See BODY CONTROL MODULE  under PROGRAMMING. After replacement, go to next step.
  7. Operate system to verify repair. If condition has been corrected, system is operating correctly at this time. If condition has not been corrected, repeat test procedure beginning at step  2.
scientia non olet · About LEMON Manuals