Removal & Installation (Except "F" Body 5.7L)
- Disconnect negative battery cable. Remove serpentine belt. Place a drain pan under vehicle. Remove or reposition, as necessary, coolant reservoir and power steering pump pulley. See POWER STEERING PUMP PULLEY .
- Remove air cleaner housing, (if necessary). Remove pressure and return hoses from pump. On "W" and "G" bodies, remove fuel injector site shield. Remove ABS wiring harness and bracket (if equipped). On "C" body remove right outer tie rod using Tie Rod Remover (J-24319-01). See OUTER TIE ROD . Remove pump mounting bolts. Remove pump.
- To install, reverse removal procedure. Fill and bleed hydraulic system. See HYDRAULIC SYSTEM BLEEDING under LUBRICATION.