LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Metro Base, 2D Hatchback >> Repair and Diagnosis >> Steering >> Power Steering >> Power Rack & Pinion Steering >> Lubrication >> Hydraulic System Bleeding

Hydraulic System Bleeding

NOTE: If air is introduced into hydraulic system during servicing, bleed system. Aerated fluid, which appears Light Tan in color, results in poor steering performance and may cause pump damage.
  1. Turn ignition off. Raise and support vehicle with wheels off ground. Turn wheels fully to left. Add power steering fluid to FULL COLD mark on dipstick. Leave cap off. Turn wheels from side to side several times, but DO NOT touch steering stops. Add fluid, if necessary, to maintain level at FULL COLD mark.
  2. Start engine. With engine idling, recheck fluid level. Add fluid, if necessary, to bring level to FULL COLD mark. Install cap. Return wheels to center position. Lower vehicle. Continue to run engine for 2-3 minutes. Road test vehicle. Check for leaks. Ensure fluid level is at FULL HOT mark when fluid stabilizes at operating temperature.
scientia non olet · About LEMON Manuals