LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Electronic >> Diagnostics - CCM On-Board Diagnostics >> Resetting Change Oil Indicator

Resetting Change Oil Indicator

  1. Turn ignition on, with engine off. DO NOT  ground terminal No. 12 (CCM) of Data Link Connector (DLC).
  2. Using DIC keypad, press and release ENG/MET button. Within 5 seconds, press it again. Within 5 seconds, press and hold GAUGES button. See Figure . CHANGE OIL indicator will flash.
  3. Hold GAUGES button until CHANGE OIL indicator stops flashing and goes out (about 10 seconds). Reset cycle is complete. If indicator does not reset, repeat procedure from beginning.
scientia non olet · About LEMON Manuals