LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1994 >> Astro Van Cargo Extended, 4.3 W, RWD >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front Torsion Bar (4WD & AWD) >> Removal & Installation >> Steering Knuckle >> Installation

Steering Knuckle: Installation

  1. Using hammer and Steering Knuckle Seal Installer (J-28574 ), install NEW steering knuckle grease seal into steering knuckle. Install spacer (if equipped). Install steering knuckle onto upper and lower ball joint studs.
    CAUTION: When installing upper and lower ball joint stud nuts, tighten nut to align cotter pin hole. DO NOT tighten ball joint stud nuts more than an additional 1/6 turn to align cotter pin hole. Complete tightening of ball joint stud nuts with vehicle at proper riding height specification.
  2. Install ball joint stud nuts and cotter pins. Install drive axle (if removed). Install tie rod end onto steering knuckle. Install tie rod end stud nut and cotter pin. Install splash shield. Install hub and bearing assembly onto drive axle shaft and into steering knuckle.
  3. To complete installation, reverse removal procedure. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS  . Lower vehicle. Check wheel alignment and adjust ride height. See WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES article in the WHEEL ALIGNMENT Section.
Fig 1: Unloading Torsion Bar Tension
G30200Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals