Stabilizer Bar: Installation
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1992 Oldsmobile Bravada, 1992 GMC Yukon, 1992 GMC Suburban, 1992 GMC Sonoma, and 1992 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
- Unload torsion bar tension. See Figure . Count exact number of tool turns for reassembly reference.
- To install, reverse removal procedure. Install NEW bushings on stabilizer bar. Ensure split in bushing faces toward front of vehicle. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS table at end of article. Lower vehicle. Check wheel alignment and adjust ride height. See ALIGNMENT SPECIFICATIONS/PROCEDURES article in the WHEEL ALIGNMENT Section.