LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1990 >> Step Van 7.4 N, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Suspension - Front (4WD) - Torsion Bar) >> Removal & Installation >> Steering Knuckle >> Installation

Steering Knuckle: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1990 GMC S15 Pickup, 1990 GMC S15 Jimmy, 1990 GMC Pickup, 1990 GMC Cab & Chassis, and 1990 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new knuckle grease seal using hammer and Front Hub Knuckle Inner Seal Installer (J-28574 ). Install spacer. Install knuckle onto ball joint studs.
  2. Attach ball joint mounting nuts. Install tie rod nut. Install hub and bearing assembly onto axle shaft and into knuckle. Tighten drive axle nut. See TORQUE SPECIFICATIONS  at end of article.
  3. To complete installation, reverse removal procedure. Check and adjust ride height. See Figure and Figure . Check front end alignment as necessary. See WHEEL ALIGNMENT article.
scientia non olet · About LEMON Manuals