LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> XT5 Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Automatic Transmission - 9T60 (M3G) Or 9T65 (M3W) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Control Valve Body Cover Replacement (LSY) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fig 1: Exploded View Of Control Valve Body Cover Components With Tightening Sequence
    GM4376124Courtesy of GENERAL MOTORS COMPANY

    Control Valve Body Cover (3) - Install - Control Valve Body Cover Installation

  2. Automatic Transmission Fluid Cooling Exchanger - Install - Automatic Transmission Fluid Cooling Exchanger Replacement (LSY)
  3. Transmission Fluid Cooler Inlet and Outlet Pipe - Install - Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LSY)
  4. Automatic Transmission Fluid Cooling Heat Exchanger Inlet Pipe - Install - Automatic Transmission Fluid Cooling Heat Exchanger Inlet Pipe Replacement (LSY)
  5. GM4674675Courtesy of GENERAL MOTORS COMPANY

    Transmission Wiring Harness Electrical Connector (1) - Connect

  6. GM5639219Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Wiring harness not shown for graphic clarity.

    Position the transmission fluid cooler pipe bracket (4) as necessary.

  7. Position the transmission wiring harness with bracket (3) as necessary.
  8. Engine Wiring Harness Transmission Clip Nut (2) - Install and tighten [2x] 9 N.m (80 lb in)
  9. Automatic Transmission Wiring Harness Retainer (1) - Install [2x]
  10. Charge Air Cooler Inlet Air Tube - Install - Charge Air Cooler Inlet Air Tube Replacement
  11. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
  12. Fill the transmission to the proper level with NEW transmission fluid.
scientia non olet · About LEMON Manuals