Control Valve Body Cover Installation

WARNING: This page is about a different car, the 2020 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Control Valve Body Cover Components With Tightening Sequence

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Body Side Wiring Harness Opening Seal Procedure Install a NEW seal. Do NOT reuse the old seal.
2	Control Valve Body Cover Gasket Procedure Install a NEW gasket. Do NOT reuse the old gasket.
3	Control Valve Body Cover
4	Control Valve Body Cover Bolt [6x] CAUTION: Refer to Fastener Caution . Tighten in sequence 11 N.m (8 lb ft)
5	Control Valve Body Cover Stud [6x] Tighten in sequence 11 N.m (8 lb ft)