LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> XT5 Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Automatic Transmission - 9T60 (M3G) Or 9T65 (M3W) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Control Valve Body Cover Replacement (LGX V08) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fig 1: Exploded View Of Control Valve Body Cover Components With Tightening Sequence
    GM4376124Courtesy of GENERAL MOTORS COMPANY

    Control Valve Body Cover (3) - Install - Control Valve Body Cover Installation

  2. GM4674675Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) - Connect

  3. GM5342134Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Wiring harness not shown for graphic clarity.

    Position the transmission wiring harness with brackets (3) as necessary.

    4. CAUTION:

    Refer to Fastener Caution .

  4. Engine Wiring Harness Transmission Clip Nut (2) - Install and tighten [2x] 9 N.m (80 lb in)
  5. Wiring Harness Retainer (1) - Install [2x]
  6. Battery Tray - Install - Battery Tray Replacement
  7. Fill the transmission to the proper level with NEW transmission fluid.
scientia non olet · About LEMON Manuals