Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Serial Data Gateway Bracket (2) - Remove - Serial Data Gateway Bracket Replacement
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Outer Air Outlet Inner Duct - Left Side (1) - Remove - Instrument Panel Outer Air Outlet Inner Duct Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Outer Air Outlet Inner Duct - Right Side (1) - Remove - Instrument Panel Outer Air Outlet Inner Duct Replacement - Right Side
Courtesy of GENERAL MOTORS COMPANY

Windshield Wiper Transmission (2) - Remove - Windshield Wiper Transmission Replacement
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Tie Bar Brace Bolt (1) - Remove [ 3x ]
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Tie Bar Bolt (1) - Remove [ 4x ]
Front Compartment Fuse Block Bolt (2) - Remove [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Tie Bar Bolt (1) - Remove [ 4x ]
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Tie Bar Bolt (1) - Remove
Heater and Air Conditioning Evaporator and Blower Module Bolt (2) - Remove [ 6x ]
Note the location and routing of the instrument panel wiring harness prior to removal to ensure proper installation.
Disconnect the wiring harness from the instrument panel tie bar assembly.
Support the HVAC module in order to prevent damage.
Courtesy of GENERAL MOTORS COMPANY

With the aid of an assistant, remove the instrument panel tie bar assembly from the vehicle. (1)
Transfer components as necessary.