Assemble Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Engine Block Oil Gallery Plug Cap (1) - Install [2x]
- Engine Block Oil Gallery Plug M16 (2) - Install and tighten [2x] 40 N.m (30 lb ft)
- Cylinder Head Locating Pin (3) - Install [2x]
- Knock Sensor (4) - Install
- Knock Sensor Bolt (5) - Install - Knock Sensor Replacement - Bank 2
- Engine Oil Pressure Sensor (6) - Install - Engine Oil Pressure Sensor Replacement
- Engine Block Core Hole Plug (7) - Install and tighten 45 N.m (33 lb ft)
- Engine Block Oil Gallery Plug M16 (8) - Install and tighten 40 N.m (30 lb ft)
- Piston Oil Nozzle (9) - Install [3x]
- Piston Oil Nozzle Bolt (10) - Install and tighten [3x] 10 N.m (89 lb in)
- Engine Front Cover Stud (11) - Install and tighten [3x] 15 N.m (11 lb ft)
Cylinder Head Locating Pin (1) - Install [2x]
- Engine Block Core Hole Plug (2) - Install and tighten [2x] 40 N.m (30 lb ft)
- Crankshaft Position Sensor (3) - Install
- Crankshaft Position Sensor Bolt (4) - Install - Crankshaft Position Sensor Replacement
- Knock Sensor (5) - Install
- Knock Sensor Bolt (6) - Install - Knock Sensor Replacement - Bank 1
- Knock Sensor Heat Shield (8) - Install
- Knock Sensor Heat Shield Bolt (7) - Install and tighten [2x] 10 N.m (89 lb in)
- Engine Block Oil Gallery Plug M16 (9) - Install and tighten [2x] 40 N.m (30 lb ft)
- Engine Coolant Heater (10) - Install and tighten [2x] 9 N.m (80 lb in)
- Crankshaft Rear Oil Seal Housing Locating Pin (11) - Install [2x]
- Engine Block Oil Gallery Plug M16 (12) - Install and tighten [2x] 40 N.m (30 lb ft)
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant