Crankshaft Position Sensor Replacement

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedure Warm Up Three-Way Catalytic Converter Replacement - Right Side (LGY) Catalytic Converter Heat Shield - Reposition - Catalytic Converter Heat Shield Replacement (LSY, LGY)
1	Crankshaft Position Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Crankshaft Position Sensor Procedure Disconnect the electrical connector. Lubricate the O-ring seal with clean engine oil. Perform the crankshaft position variation learn. Crankshaft Position Variation Learn

Callout

Component Name

Preliminary Procedure

Warm Up Three-Way Catalytic Converter Replacement - Right Side (LGY)
Catalytic Converter Heat Shield - Reposition - Catalytic Converter Heat Shield Replacement (LSY, LGY)

Crankshaft Position Sensor Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Crankshaft Position Sensor

Procedure

Disconnect the electrical connector.
Lubricate the O-ring seal with clean engine oil.
Perform the crankshaft position variation learn. Crankshaft Position Variation Learn