LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Engine Mechanical - 3.6L (LF4) - Repair Instructions (3 Of 4)) >> Repair Instructions >> Piston and Connecting Rod Overhaul >> Connecting Rod Bearing Assemble Procedure

Connecting Rod Bearing Assemble Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM1313403
    NOTE:

    If the connecting rod bearings have been used in a running engine, you must replace them with NEW connecting rod bearings for reassembly.

    Clean the connecting rod (2) and the connecting rod cap bearing bore with a lint-free cloth.

  2. Clean all the oil from behind the connecting rod bearing halves.
  3. Install NEW upper connecting rod bearing (1) into position. Roll the bearing into position so that the lock tang engages the alignment slot. The bearing must fit flush in the connecting rod.
  4. Install the EN-46121  Connecting Rod Guide Pin Set into the connecting rod bolt holes.
  5. GM1313743

    Install NEW lower connecting rod bearing (1) into position in the connecting rod cap (2). Roll the bearing into position so that the lock tang engages the alignment slot. The bearings must fit flush with the connecting rod cap.

scientia non olet · About LEMON Manuals