Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Front Crossmember Brace (3) - Install

CAUTION:

Refer to Fastener Caution

Front Crossmember Brace Bolt (1) - Install and tighten [4x] - Fastener Specifications
Front Crossmember Brace Nut (2) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Push Pin (2) @ Front Wheelhouse Liner (1) - Install
Courtesy of GENERAL MOTORS COMPANY

{ If equipped } Front Crossmember Brace (2) - Install
{ If equipped } Front Crossmember Brace Nut (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Air Deflector (2) - Install
Front Compartment Air Deflector Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner Bolt (3) - Install and tighten - Fastener Specifications
Push Pin (2) - Install [2x]
Engine Front Splash Shield Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner Bolt (1) - Install and tighten - Fastener Specifications
Push Pin (2) - Install [2x]
Engine Front Splash Shield Bolt (3) - - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Push Pin (2) - Install [2x]
Front Bumper Fascia Center Air Deflector Bolt (1) - Install and tighten [5x] - Fastener Specifications
Lower the vehicle.