Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Install the rear bumper lower fascia (2) to the rear bumper upper fascia.
- Rear Bumper Fascia Bolt (1) - Install and tighten [2x] Fastener Specifications
Install the 2 rear fascia signal lamps to the left and right side (2).
- Install the 3 left and right side rear fascia signal lamp bolts (1). Fastener Specifications
Exhaust Tail Pipe Heat Sleeve (3) - Install [2x]
- Rear Bumper Fascia Bolt (2) - Install and tighten [2x] Fastener Specifications
- Install the 2 exhaust tail pipe heat sleeve rivets to the left and right side of the rear bumper fascia (1).
Rear Bumper Fascia Energy Absorber (3) - Install
- Rear Bumper Fascia Energy Absorber Bolt (2) - Install [2x] Fastener Specifications
- Rear Bumper Fascia Energy Absorber Clip (1) - Install [4x]
- Install the wiring harness.
- Connect the electrical connector from the low frequency rear bumper antenna.
- Connect the rear parking sensor electrical connector
Rear Bumper Fascia (1) - Install - Rear Bumper Fascia Removal and Installation (without Blackwing) , or Rear Bumper Fascia Removal and Installation (with Blackwing)
CAUTION:
Refer to Fastener Caution .