Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Crankshaft Position Sensor Shield (2) - Install
- Crankshaft Position Sensor Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications
Install the front cradle sheer plate (2) between the front bumper fascia center air deflector and the driveline and front suspension cradle and raise into position.
- Ensure that the left and right side wheelhouse liners (1) are positioned in place under the front cradle sheer plate (2).
Front Wheelhouse Liner Bolt (1) - Install and tighten [2x] - Fastener Specifications
Front Crossmember Brace Bolt (3) - Install and tighten [8x] - Fastener Specifications
- Front Cradle Shear Plate Nut (2) - Install and tighten [2x] - Fastener Specifications
- Front Cradle Shear Plate Bolt (1) - Install and tighten [4x] - Fastener Specifications
- Remove the jack.
Front Bumper Fascia Air Deflector Retainer (2) - Install
- Front Bumper Fascia Air Deflector Bolt (1) - Install and tighten [4x] - Fastener Specifications
- NOTE:
Left side shown, right side similar.
Front Compartment Air Deflector- Left Side and Right Side (1) - Install
- NOTE:
Left side shown, right side similar.
Front Bumper Fascia Lower Stiffener Bolt- Left Side and Right Side (3) - Install and tighten [6x] - Fastener Specifications
- Front Compartment Air Deflector Retainer- Left Side and Right Side (2) - Install [2x]
- Front Wheelhouse Liner Bolt- Left Side and Right Side (1) - Install and tighten [4x] - Fastener Specifications
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .