Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Front Brake Hose (1) - Install
Remove the plug from the front brake caliper inlet.
- Front Brake Hose Washer (3) - Install NEW [2x]
- Front Brake Hose (2) @ Front Brake Caliper - Install
- Front Brake Hose Fitting (1) - Install and tighten - Fastener Specifications
Remove the cap from the front brake pipe outlet.
- Front Brake Hose Retainer (2) - Install
- Front Brake Pipe Nut (1) - Install and tighten - Fastener Specifications
- Front Brake Hose Fitting Bolt (3) - Install and tighten - Fastener Specifications
Install the front wheel speed sensor (3) at the 2 wiring harness retainers (2).
- If equipped, install the front disc brake pad wear sensor (4) at the 4 wiring harness retainers (1, 2).
- Wiring Harness Retainer (2) - Engage [2x]
- { If equipped } Wiring Harness Retainer (1) - Engage [2x]
- Bleed the brake system. Hydraulic Brake System Bleeding (JE5, J6G) , or Hydraulic Brake System Bleeding (J55)
- Check for brake system leaks.
- NOTE:
- Quantity of fasteners may vary based on option content.
- Some components not shown for graphic clarity.
Engine Front Splash Shield (3) - Install
- Engine Front Splash Shield Bolt (1) - Install and tighten [4x] - Fastener Specifications
- Engine Front Splash Shield Retainer (2) - Install
- Install the front tire and wheel assembly. Tire and Wheel Removal and Installation
- Remove the support and lower the vehicle.
CAUTION: