Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Use the original shim count as a starting point to determine the proper air gap for the air conditioning clutch plate.

Install the air conditioning clutch shim (s) (2) as needed to achieve the appropriate air gap of 0.25 - 0.41 mm (0.010 - 0.016 in).
Courtesy of GENERAL MOTORS COMPANY

Install and hand tighten the air conditioning clutch drive plate (1).
Measure the air gap between air conditioning clutch drive plate (1) and the air conditioning compressor pulley (2) using the appropriate feeler gauge (3).
If the air gap is out of range remove the air conditioning clutch drive plate, and add or remove shim (s) as need to achieve the appropriate air gap.
Repeat steps 2, 3, and 4 as needed to achieve the appropriate air gap.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Component Fastener Tightening Caution

Use the appropriate tool to hold the air conditioning compressor shaft (3), and the appropriate tool to turn air conditioning clutch drive plate (1) clockwise to tighten. Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of fasteners may vary based on option content.

Front Compartment Air Deflector (2) - Install

CAUTION:

Refer to Fastener Caution

Front Compartment Air Deflector Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of fasteners may vary based on option content.

Front Wheelhouse Liner Bolt (3) - Install and tighten - Fastener Specifications
Engine Front Splash Shield Retainer (2) - Install [2x]
Engine Front Splash Shield Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of fasteners may vary based on option content.

Front Wheelhouse Liner Bolt (1) - Install and tighten - Fastener Specifications
Engine Front Splash Shield Retainer (2) - Install [2x]
Engine Front Splash Shield Bolt (3) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of fasteners may vary based on option content.

Front Bumper Fascia Center Air Deflector Retainer (2) - Install [2x]
Front Bumper Fascia Center Air Deflector Bolt (1) - Install and tighten [5x] - Fastener Specifications
Lower the vehicle.