Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Rear Shock Absorber (1) - Install
- CAUTION:
Refer to Fastener Caution .
Rear Suspension Shock Absorber Upper Mounting Nut (1) - Install and tighten [3x] - Fastener Specifications
- Electrical Connector (2) - Connect
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Rear Shock Absorber Bolt (2) @ Rear Suspension Lower Control Arm (3) - Install NEW and tighten - Fastener Specifications
- Remove the jack from beneath the rear suspension lower control arm.
Rear Suspension Lower Control Arm Cover (2) - Install
- Install the 4 rear spring pins (1).
Rear Wheelhouse Liner (5) - Install
- Retainer (3) - Install [2x]
- Push Pin (1) - Install
- Rear Bumper Fascia Screw (4) - Install and tighten [2x] - Fastener Specifications
- Rear Wheelhouse Liner Screw (2) - Install and tighten [8x] - Fastener Specifications
Rear Tire Front Air Deflector (2) - Install
- Rear Tire Front Air Deflector Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation
- Remove the support and lower the vehicle.