Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
With the aid of an assistant, install the console to the vehicle. (1)
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
- Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
- Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the component.
- Position the transmission control lever boot and knob assembly (1, 2) on the manual transmission control lever.
- Manual Transmission Control Lever Knob Bolt (3) - Install and tighten - Fastener Specifications .
- Install the manual transmission control lever boot (2) to the console.
Front Floor Console Bracket Bolt (1) - Install and tighten - Fastener Specifications
- Front Floor Console Bolt (2) - Install and tighten [3x] - Fastener Specifications
Connect the electrical connectors (1) to the front floor console wiring harness.
- Front Floor Console Bolt (2) - Install and tighten [3x] - Fastener Specifications
- Front Floor Console Bracket Bolt (3) - Install and tighten - Fastener Specifications
Front Floor Console Extension Panel - Left Side (2) - Install
Front Floor Console Extension Panel - Right Side (2) - Install
- Front Floor Console Rear Trim Panel (1) - Install
- Return the seat to its original position.
CAUTION:
Refer to Fastener Caution .