Installation Procedure
- CAUTION:
Refer to Component Fastener Tightening Caution .
Engine Coolant Heater (1) - Install and tighten 50 N.m (37 lb ft)
Engine Coolant Heater Cord (1) @ Engine Coolant Heater (2) - Connect
Install the generator (1) with the lower generator mounting bolt (2).
- CAUTION:
Refer to Fastener Caution
Generator Bolt (2) - Install and tighten - Fastener Specifications
- Generator Bolt (1) - Install and tighten - Fastener Specifications
Auxiliary Generator Battery Jumper Cable (2) - Install
- Battery Positive Cable Nut (1) @ Generator - Install and tighten - Fastener Specifications
Electrical Connector (1) - Connect
Radiator Inlet Hose Bracket (2) - Install
- Radiator Inlet Hose Bracket Bolt (1) - Install and tighten - Fastener Specifications
Install the air conditioning compressor hose bracket into position.
- Air Conditioning Evaporator Tube Clip Bracket Bolt (4) - Install and tighten - Fastener Specifications
Charge Air Cooler Outlet Air Tube (2) @ Charge Air Cooler (3) - Install
- Retainer Spring (1) - Engage
Front Wheelhouse Liner (3) - Install
- Front Wheelhouse Liner Retainer (2) - Install [4x]
- Front Wheelhouse Liner Bolt (1) - Install and tighten - Fastener Specifications
Front Bumper Fascia Center Air Deflector Bolt (1) - Install and tighten [3x] - Fastener Specifications
- Front Bumper Fascia Bolt (2) - Install and tighten [2x] - Fastener Specifications
Engine Front Splash Shield (3) - Install
- Engine Front Splash Shield Retainer (2) - Engage [2x] - Fastener Specifications
- Engine Front Splash Shield Bolt (1) - Install and tighten [5x] - Fastener Specifications
Tire and Wheel Assembly-Left Front (2) - Install - Tire and Wheel Removal and Installation
Front Tire Front Air Deflector (2) - Install
- Front Tire Front Air Deflector Bolt (1) - Install and tighten [4x] - Fastener Specifications
- Lower the vehicle.
Charge Air Cooler Outlet Air Tube (2) @ Throttle Body - Install
- Retainer Spring (1) - Engage
Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Install
Push down on the front of the intake manifold cover (1).
Using an appropriate tool, rotate the drive belt tensioner (1) counterclockwise and hold tension.
Accessory Drive Primary Belt (1) - Install
- Slowly release tension on the accessory drive primary belt.
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Fill the cooling system. Refer to Cooling System Draining and Filling (L3B Static Fill) , or Cooling System Draining and Filling (L3B GE 47716)
- Inspect for coolant leaks.
Quantity of fasteners may vary based on option content.
Quantity of fasteners may vary based on option content.