Installation Procedure
Auxiliary Radiator Front Duct (1) - Install
Front Bumper Impact Bar (2) - Install
- Front Bumper Impact Bar Bolt (1) - Install and tighten [8x] - Fastener Specifications
- Install the wiring harness.
- NOTE:
Left side shown, right side similar.
Horn- Left Side and Right Side (2) - Install [2x]
- Horn Bolt- Left Side and Right Side (1) - Install and tighten [2x] - Fastener Specifications
- NOTE:
Left side shown, right side similar.
Transmission Fluid Auxiliary Cooler Bracket Bolt- Left Side and Right Side (2) - Install and tighten [2x] - Fastener Specifications
- Auxiliary Radiator Front Inlet Duct- Left Side and Right Side (1) - Install [2x]
{ If equipped } Forward Range Radar Bracket (2) - Install
- { If equipped } Forward Range Radar Bracket Bolt (1) - Install and tighten [3x] - Fastener Specifications
- { If equipped } Connect the electrical connector.
Auxiliary Radiator Duct Retainer- Right Side (1) - Install [2x]
Auxiliary Radiator Duct Retainer- Right Side (1) - Install [3x]
Front Bumper Fascia (1) - Install - Front Bumper Fascia Removal and Installation (without Blackwing) , or Front Bumper Fascia Removal and Installation (with Blackwing) , or Front Bumper Fascia Removal and Installation (with Blackwing CFV, CFZ)
Auxiliary Radiator Rear Duct- Right Side (1) - Install
Auxiliary Radiator Duct Retainer- Right Side (1) - Install [3x]
- NOTE:
Left side shown, right side similar.
Front Wheelhouse Liner- Right Side (3) - Move into position
- Front Wheelhouse Liner Retainer- Right Side (2) - Install
- Front Wheelhouse Liner Bolt- Right Side (1) - Install and tighten [4x] - Fastener Specifications
- NOTE:
- Left side shown, right side similar.
- Quantity of fasteners may vary based on option content.
- Some components not shown for graphic clarity.
Engine Front Splash Shield- Right Side (3) - Install
- Engine Front Splash Shield Bolt- Right Side (1) - Install and tighten [4x] - Fastener Specifications
- Engine Front Splash Shield Retainer- Right Side (2) - Install
- Install the right front tire and wheel assembly. Tire and Wheel Removal and Installation
- NOTE:
Left side shown, right side similar.
Front Bumper Fascia Air Deflector- Outer (2) - Install
- Front Bumper Fascia Air Deflector Bolt- Right Side (1) - Install and tighten [4x] - Fastener Specifications
- NOTE:
Left side shown, right side similar.
Front Bumper Fascia Lower Reinforcement- Right Side (2) - Install
- Front Bumper Fascia Air Deflector Bolt- Right Side (1) - Install and tighten [6x] - Fastener Specifications
- NOTE:
Left side shown, right side similar.
Front Bumper Fascia Air Deflector Bolt- Right Side (3) - Install and tighten [4x] - Fastener Specifications
- Front Bumper Fascia Lower Stiffener Bolt- Right Side (2) - Install and tighten - Fastener Specifications
- Front Bumper Fascia Bolt- Right Side (1) - Install and tighten [6x] - Fastener Specifications
- Lower the vehicle.