Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Auxiliary Radiator Front Duct (1) - Install
Front Bumper Impact Bar (2) - Install
- Front Bumper Impact Bar Bolt (1) - Install and tighten [8x] - Fastener Specifications
- Install the wiring harness.
Horn (2) - Install [2x]
- Horn Bolt (1) - Install and tighten [2x] - Fastener Specifications
Front End Sheet Metal Cross Brace (2) - Install [2x]
- Front End Sheet Metal Cross Brace Bolt (1) - Install and tighten [4x] - Fastener Specifications
Intake Air Duct Retainer (1) - Install [2x]
- Radiator Air Lower Seal Retainer (2) - Install [2x]
- Radiator Air Lower Baffle Retainer (3) - Install [2x]
- NOTE:
The front bumper fascia support brace (2) may have a forward range radar sensor attached, if equipped.
Front Bumper Fascia Support Brace (2) - Install
- Front Bumper Fascia Support Brace Bolt (1) - Install and tighten [3x] - Fastener Specifications
- Connect the electrical connector to the forward range radar sensor, if equipped.
Auxiliary Radiator Duct Retainer (1) - Install [2x]
Auxiliary Radiator Duct Retainer (1) - Install [3x]
- Install the front bumper fascia. Front Bumper Fascia Removal and Installation (without Blackwing) , or Front Bumper Fascia Removal and Installation (with Blackwing) , or Front Bumper Fascia Removal and Installation (with Blackwing CFV, CFZ)
CAUTION:
Refer to Fastener Caution .